Jeep Wrangler Parking Brake Lever Assembly | Genuine Chrysler 52059887AE

Genuine Chrysler part no 52059887AE is the exact replacement Jeep Wrangler Parking Brake Lever Assembly for the models 2007, 2008,2009, and 2010 and it’s easy to install.

Check out the list below for detailed Compatibility.

VEHICLE COMPATIBILITY

YEAR	MAKE	MODEL	BODY & TRIM	ENGINE & TRANSMISSION
2010	Jeep	Wrangler	Rubicon, Sahara, Sport, Unlimited Rubicon, Unlimited Sahara, Unlimited Sport	3.8L V6 – Gas
2009	Jeep	Wrangler	Rubicon, Sahara, Unlimited Rubicon, Unlimited Sahara, Unlimited X, X	3.8L V6 – Gas
2008	Jeep	Wrangler	Rubicon, Sahara, X	3.8L V6 – Gas
2007	Jeep	Wrangler	Rubicon, Sahara, X	3.8L V6 – Gas

Promising review: Perfect fit for 2008 Wrangler JK

Spring snapped on the original brake handle. This was an exact fit in a 2008 Wrangler JK. Remove all screws from the center console.

Prop up the back of the console with a piece of wood. Disconnect cables and unbolt the original handle. Bolt-in new handle and attach cables. (4 bolts in total)

The mechanic’s instructions state the entire center console must be removed, but there’s enough room to swap the handle just from the back.

Cut a piece of wood 10-14 inches long or have a family member hold the console up while you remove and install the bolts.

*Note, that the new handle comes with a spring retaining clip. Do not remove the clip until the handle is bolted in place and the brake cables are attached.

If you do, the spring is released early and you can toss the handle in the garbage.

You might think you cannot squeeze the new handle through the console slot with the spring retaining clip in place, but, you can and must. It fits. Do it.- no comment